TSXClub.com Forums - View Single Post

Carmagnut · 10-08-2009, 01:04 PM

This is a copy of a thread on another forum. So far it has got some looks but no one has chimed in. I want to get this done this weekend. Any help is appreciated.

I tried to replace the rear (after cat) o2 sensor on my 06 TSX. I had the car jacked up and found where everything seems to go. Basic question: after pulling out the rubber plug that some of the wires go through, (not on the o2 sensor side, the other side (the one the plugs into the car), do I just pull the existing plug out and put the new plug in? Is it that simple? We did not want to yank too hard and break something with the fear that it would be too hard to get out after something snapped. I fgured I would come to the 'club and see if someone could help. Thanks.

10-08-2009, 01:04 PM	#1 (permalink)
Carmagnut Registered Member Join Date: Apr 2009 My Ride: 2006 Acura TSX Posts: 69 iTrader: (0)	06 o2 Sensor Replacement This is a copy of a thread on another forum. So far it has got some looks but no one has chimed in. I want to get this done this weekend. Any help is appreciated. I tried to replace the rear (after cat) o2 sensor on my 06 TSX. I had the car jacked up and found where everything seems to go. Basic question: after pulling out the rubber plug that some of the wires go through, (not on the o2 sensor side, the other side (the one the plugs into the car), do I just pull the existing plug out and put the new plug in? Is it that simple? We did not want to yank too hard and break something with the fear that it would be too hard to get out after something snapped. I fgured I would come to the 'club and see if someone could help. Thanks.