Acura TSX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello
working on replacing the rear strut assembly. I am at the point where I need to put the new one in
I looked around on how to do this and it appears I need to press on the arms to lower them so I can fit the suspension back in
I tried that for a bit but it is a pain and really difficult. I thought about removing the castle nut tying the upper control arm. would that lower the bottom section so I can position the strut in place?
Appreciate the tip on this
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top