Acura TSX Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
742 Posts
Discussion Starter · #1 · (Edited)
Part
08W60-SEC-200B, theoretically for 04-05 MT but fits AT and 06-08 as well.
I read that 06-08 aspec (200D) the front sits lower than 04-05 one, but damper wise they perform the same.

Price
Asking $220 + shipping

Location
SF bay area, local pickup preferred but shipping ok at buyer's expense.

Condition
~38k miles, still in good condition with ample damping.

Sorry for the poor pic quality. I will retake with a better camera..

Bought these brand new from Curry Acura. Upgraded my suspension so these are up for sale. PM me if interested!
 

·
Registered
Joined
·
742 Posts
Discussion Starter · #3 ·

·
Registered
Joined
·
742 Posts
Discussion Starter · #6 ·
i think the aspec drops a bit less than an inch, but that's about it
Wish you were closer. Silly question but how much lower did your car sit?
That's about right, for me the drop was about 1 finger less front and rear compared with stock. Specifically, the gaps were 14.5" front and 14" rear on 04 AT, measured from hub center to wheel arch.
 

·
Registered
Joined
·
742 Posts
Discussion Starter · #8 ·
FYI shipping around $80 to east coast via FedEX.
 

·
Registered
Joined
·
742 Posts
Discussion Starter · #9 ·
Sold!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top