Acura TSX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter #1
I want to use Morimoto ballasts to replace the OEM ballasts on my gfs 05 TSX. I figure I should replace them as they're 6 years old now and the car has 180,000 kms so its been driven a lot.

Now the Morimotos have a 9006 input to connect to. The output connector is D2S.

What kind of conversion harness would I need if one exists for the TSX. I've searched and cant find what the TSX output harness is supposed to look like. Is it the same connector as a Matsushita?

What did you guys get for aftermarket ballast replacements and how did it wire up?
 

·
" It Is What It Is "
Joined
·
7,490 Posts
I'm running www.ddmtuning.com hid kit for my low beam... check them out... I have the slim one and a year later its still going with no issues...
 

·
Registered
Joined
·
44 Posts
Discussion Starter #3
i prefer the Morimotos. potted and and waterproof.

if anything i'll just splice the wires and use a 9006 input. just wondering if there were any plug and play conversion harnesses that i could use.
 
1 - 3 of 3 Posts
Top