Acura TSX Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
I didn't which thread to put this in, but when you roll your rear fenders do you have to cut away the plastic liner ? Because it's sitting on top of lip or could you just roll over the plastic?
 

·
Registered
Joined
·
552 Posts
I was planning to roll it flat and if I leave the lining in won't be that flat would it?
Correct. You will probably gain about 2-3mm of clearance without the lining. If you need that much, be prepared to cut the lining where the bumper bolt is and relocate the bolt. Depending on your wheel specs, you'll need to trim the bumper too.

I am running 18x9 +24, 215/40 and had to do all of the above
 

·
Registered
Joined
·
111 Posts
Discussion Starter · #9 ·
Correct. You will probably gain about 2-3mm of clearance without the lining. If you need that much, be prepared to cut the lining where the bumper bolt is and relocate the bolt. Depending on your wheel specs, you'll need to trim the bumper too.

I am running 18x9 +24, 215/40 and had to do all of the above
Alright thanks. I just want to roll it flat for the future just incase I want to go more agressive later.
 
1 - 13 of 13 Posts
Top