Fog Light problem (Solved post #2 :) )

723 Views 1 Reply 1 Participant Last post by w00dman, Dec 30, 2012

w00dman

Discussion Starter · Dec 29, 2012

Hi,

I've bought a kit from K2Motor and installed it with the push button.

Today I've changed it and installed a combination switch with front fog light option.

Followed the installation instructions given by Peregrine carefull but now they don't work.
The light on dash panel lights up but the 12v signal (to relay coil) given by 14pin connector isn't there.

Have anyone have the same issue or there's any fuse that I have to check?

Thanks

Save

1 - 2 of 2 Posts

w00dman

Discussion Starter · #2 · Dec 30, 2012

"Problem" solved.

The pin #3 on 14 pin connector doesn't carry a 12v signal. When you turn on your fog lights this pin is connected to ground instead carrying 12v to activate the relay coil.

Thanks

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month