Acura TSX Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
186 Posts
Hi,

Need a header very soon - flex pipe in mine going bad. Comptech or CT Engineering preferred.

If not, it at least hast to fit in the factory location - i.e. no PLM or anything else that needs test pipe, etc.

Thank you!
There's a bunch on ebay for 180 and up or you can do like I did

 

·
Triple Platinum Member
Joined
·
595 Posts
Discussion Starter #6
PLM with a magnaflow cat and flex pipe instead of test pipe. Make sure you either install a second 02 bung so pre and post on the collectors or wait until you tune it to use a single pair.
No, thank you.

I would like a 4-2-1 header that fits in the stock location.
 

·
Registered
Joined
·
12 Posts
I have an el-cheapo TopSpeed header that fits the stock location. Never used. New was $200, I guess I could sell it for $150 shipped. It's a copy of the DC header. Never tried to install it.
 
1 - 10 of 10 Posts
About this Discussion
9 Replies
4 Participants
feuss2
Acura TSX Forum
TSX Club is the perfect forum for Acura TSX fans and Owners, where you can discuss concerns about reliability or how to upgrade your TSX with mods and accessories.
Full Forum Listing
Top