Acura TSX Forum banner
1 - 3 of 3 Posts

·
, Administrator Emeritus
Joined
·
10,660 Posts
Discussion Starter · #1 ·
This may be common knowledge, but I just learned of this week. So I thought I'd pass it along.
The hood on my TSX was sitting too low in the front (when closed). Meaning the front of the hood was lower then the top of the side panels (fender).
There is a very simple fix for this. Open your hood. There are two rubber stoppers (at the front two corners of the car) that the hood rests on when closed. By simply turning these (clockwise, and counter clockwise) you can adjust the hight of the front of your hood when closed.
A couple turns, and my hood is now aligned perfectly! :)
 

·
, Moderator Emeritus
Joined
·
5,757 Posts
a minor defect on yours that could be fixed, cuz mines lines up just fine?:donno:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top