[SE1904]

Two questions.

1) From the looks of all four arms of the J-Power camber kit, they are interchangeable. Is that the case and does it matter which arm goes to where during installation?

2) Any advice on best location to place jack under car when raising it and the best place to place jack stand(s)?

Appreciate any advice and insight on these two matters.

 

[cl9kamina]

yea the j-power seems to be the same. put the jack on the jack point in the rear trunk where they would put the tow hook at. raise it up then put the standes on the jack points on the side. i know somewhere in the fourm there is a pictures of where to put the jack and stands. i would search there first.

 

[Kevin]

Wait just a second there... In assuming the j power is the ingalls replica right? It has 4 arms? 2 arms should be short and the other two should be long. You have to check with your manual or instructions which arm goes where

 

[cl9kamina]

o yea.. thanks kevin. there should be two long and two short for a complete set. one is for camber and the other should be for toe. which would be the long one.

 

[oligoodday]

the short arms is the camber & the long arm is for toe. also the bushing w/ the larger spacer goes w/ the short arm & the bushing w/ the smaller spacer goes to the long arm.

 

[SE1904]

Appreciate the help fellas, install went fairly smooth...now I just need to adjust the toe and camber to straighten up the tires.