Picked up some ThinkDesign carbon parts for the interior recently.
The ThinkDesign parts match the factory trim great. The weave size is slightly larger I believe but I could only just make it out when holding it right next to the center console area so you can't tell at all once they are installed. I also got some clear door lights as well to get rid of the red ones.
I included a quick install for the gauge trim. It isn't difficult but figured it might come in handy possibly. The vents are straight forward so and just pop out and the new ones clip right in.
I also picked up a Silver flat bottom wheel from Sewell but I am still waiting on that to arrive. Should have it in about 2 weeks time.
Now I just need to pickup the rear seat divider and maybe the latch to the armrest compartment in silver to finish off the interior.
Vents:
Great attention to detail in the construction
Gauge Trim:
Together:
Install:
Remove this side panel first
You can now pull down the lower trim around the steering wheel. You can remove it if you want but you don't have to.
Remove the left screw to the gauge trim.
Remove the right screw to the gauge trim.
Pop up the clips that hold the leather trim in place.
Remove two top plastic screw clips. After this you can wiggle the trim loose and out of the dash.
Reverse to install.
Before & After:
Clear Lights Before & After: