[MilanoCU2]

Guess I'll try and make a build thread.

2/23/12 When I bought the car.

4/18/12 Wheels

5/6/12 coilovers

5/16/12 lowered w/spacers

rears have been rolled and pulled, still need to modify rear bumper tabs so I can go lower, and next time around will go with probably 215 front tires so I can go lower on the front too.

 

[ppower]

It looks great! I've got a few ??

What are the wheel/tire specs?
So you pulled the fender as well? Did you roll the rear fender flat or just up at an angle?
What size spacers to you add to the rear to even out with the front?
Moar pics?

 

[TSXpath]

Looking real good there MilanoCU2!

 

[MilanoCU2]

It looks great! I've got a few ??

What are the wheel/tire specs?
So you pulled the fender as well? Did you roll the rear fender flat or just up at an angle?
What size spacers to you add to the rear to even out with the front?
Moar pics?

rears are rolled flat and pulled slightly.
Wheels are SSR Vienna's there old. 19x8.5/9.5 +50/45
Fronts have +15mm spacers and rears have +20mm spacers.
Will run a 215/225 setup next time around over the 235 squared setup

 

[ed_423]

looks hot

 

[islandbeef]

Mean lookin' ride! Good job.

 

[ppower]

rears are rolled flat and pulled slightly.
Wheels are SSR Vienna's there old. 19x8.5/9.5 +50/45
Fronts have +15mm spacers and rears have +20mm spacers.
Will run a 215/225 setup next time around over the 235 squared setup

So that's basically 8.5 +35 and 9.5 +25. Using an offset calculator, that puts the rears 23mm further out than the front. Mine are 8.5 +38 and 245 rubber, so I can now see why the rears needed a pull. When you get a chance, some shots showing the flush profile would be awesome. BTW, it's low enough already.

 

[MilanoCU2]

So that's basically 8.5 +35 and 9.5 +25. Using an offset calculator, that puts the rears 23mm further out than the front. Mine are 8.5 +38 and 245 rubber, so I can now see why the rears needed a pull. When you get a chance, some shots showing the flush profile would be awesome. BTW, it's low enough already.

Will take pictures today for ya. In the meantime, what I did yesterday to pass time at work.

 

[ed_423]

:thumbsup:

 

[CU2INDA858]

Looking real nice man... I'm diggin the center consol pieces was it difficult to do? ...great idea one the less

 

[MilanoCU2]

Looking real nice man... I'm diggin the center consol pieces was it difficult to do? ...great idea one the less

center console was pretty easy to do. From start to finish it took me about 2hrs.