Acura TSX Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
379 Posts
Discussion Starter #1
Im looking to put a new set of wheels on my TSX. Its black on black. I love the concave style of the replica volk te7's. But was alos thinking of going with the clean jdm style with Work VS-XX's. I need some help with some memebers feedback. What do you guys think i should go with?? Its a yearly driver in Buffalo NY so going the hellaflush route cant happen. But a nice drop small drop will.
 

·
Registered
Joined
·
62 Posts
I agree with funkbro2; lower offset normally equals bigger lip or concave look.

A picture of the car would help since some wheels look good on lowered cars and not on stock height cars.
 

·
" It Is What It Is "
Joined
·
7,490 Posts
a member on here selling a set of volks vs-xx check out the classified
 

·
....its fate....
Joined
·
1,276 Posts
So you're comparing vs-xx with replica te's?! Then go for the better quality works, although I am assuming that the replica's might not be as good quality.
Te37's are quite a bit lighter than the vs-xx. If you're after looks, then i would go vs-xx. If you're chasing better performance, then go the lighter volks ;)

BTW, agree with the above posts, if you want concave, you need low offset!

a member on here selling a set of volks vs-xx check out the classified
volks vs-xx would be the best of both worlds! :p
 

·
Registered
Joined
·
379 Posts
Discussion Starter #7
im undecided, im looking at the used wheel market if i were to get works or volks, replicas ill buy new. I love the concave look but i guess with the loweroffset it wont work out to well.
 
1 - 8 of 8 Posts
Top