Acura TSX Forum banner
1 - 14 of 14 Posts

·
Registered
Joined
·
1,393 Posts
Discussion Starter · #1 ·
Found a set locally for pretty cheap and it's non staggered so 17x8.5 +60 all around.

I'm just afraid of the rim hitting the shocks since the offset is so high. I couldn't find anything on NSX wheels on a TSX.

Anybody have any ideas if this would work or would I have to run spacers? I'm thinking 10mm
 

·
From Nissan to Honda
Joined
·
2,170 Posts
People who run 18x9.5 +40 hit in the rear.. Stock is 17x7+55, the offset is high but the rim itself isnt wide. You are going to increase the width 1.5 inches while bringing the rim closer to the center...

I'm thinking it'll hit more than likely. 17x8.5 +50 should work.
 

·
Fresh As F*uck
Joined
·
190 Posts
You will need minimum of 15mm or 20mm(recommended) spacers for those wheels to work. I ran ap2v1 wheels and the rears used to hit the struts with a 10mm spacer all the time over small bumps
 

·
, Regional Meet Leader, Seattle,WA
Joined
·
1,465 Posts
I ran Ap2v1's and V2's. 10mm clears just fine. Thats with 245/40's and even 255/40's... Anything below +55 should be good. I do have extended studs though.
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top