[markurl]

Hi all,

I bought the LC6i so i can run the post-amp factory speaker wires to my amp. The reason I did this was because I heard bad things about the Pac AOEMHON20. Everything seemed fine until this morning when I found out that the factory amp acts as the cross over for the front woofers and tweeters. My question is how do I take the signal from the tweeters and the front door woofers and combine them for a full spectrum signal to put into my amp so it can be redistributed to my aftermarket speakers. And just so I put it out there I am running Focal components in the front, 6.5s in the back doors and 6x9s in the rear deck, powered by the JL AUDIO 700/5 amp.

Appreciate the help ahead of time.

 

[DeSEBticoN]

it all depends what your goal is , what are you trying to acomplish ? are you staying factory HU or getting aftermarket HU ? i found this pic here i dont know if it will help you at all but ill post it anyways

TSX Audio system is the one and only audio system that ive ever had so much hard time dealing with because the factory HU and climate control sit on one control board and the audio is ran through that factory amp , only way ( in my opinion ) to deal with this is to use T Harness to split power between aftermarket and factory HU's , gut the factory amp , and rewire the whole car , pain in the @$$ to do but it makes $hit a whole lot simpler in the final run , thats just my 2 cents

 

[markurl]

Reply

The goal I am trying to accomplish is keep my factory headunit and not install anything after market except subs, speakers and amps. I was to somehow combine the line out of the amp to the tweeter and the line out of the amp to the woofer to send the signal back to the component crossover to be redistributed.