Acura TSX Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter #1
I'm about to install a Euro R rear lip on my 2004 TSX. There are three bolts on the lip along the rear of the lip and it clearly appears that you have to drill three corresponding holes in your bumper. To be clear these are not the mounting points on the bottom of the lip but the back side of the lip. For those that have installed the Euro R Rear Lip on a 2004 or 2005 TSX: Have you drilled those holes in your bumper or just relied on the other fasteners and tape?

Many thanks!

sasmf
 

·
My car whines
Joined
·
637 Posts
i have the aspec rear lip and i believe there are 2 fasteners on each side holding it (where the mudflaps usually go). this should apply for the euro r lip as well. i wouldn't risk having the lip flying off while on the freeway because the bolts weren't used :eek2:
 
1 - 2 of 2 Posts
Top