Acura TSX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
178 Posts
Discussion Starter · #1 ·
I'm trying to remove my stock AT shift knob and in order to stop myself from thinking that twisting the knob with too much pressure will break or damage something, I decided to vice grip the small visible part of the shift shaft right below the knob.

But before I do it, I just want to ask to make sure if the shaft is strong enough to withstand a huge amount of pressure from the vice-grip, assuming that it's not hollow and break or bend if I grip it..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top