Acura TSX Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
442 Posts
Discussion Starter #1
I am trying to remove it. It wont turn. I've PB Blasted the bolts twice and no luck. Any one have hinters on how to remove it?
 

·
flashprroooooo!!!
Joined
·
2,660 Posts
you can try kano kroil, which is a bit better than pb/wd-40.

other option is using a torch to heat it up. or get a shop just to loosen it and you do the rest.
 

·
Premium Member
Joined
·
8,413 Posts
Im able to crack em lose with a long breaker bar. Worked on 3 cars thus far
 

·
Registered
Joined
·
134 Posts
I usually grab a cut off wheel and cut them off. Sometimes a saws all works too. I am from the north east, so I have never gotten them to come loose unless the car is fairly new.
ditto... cut em out and just get new hardware..its cheap enough
 

·
Registered
Joined
·
442 Posts
Discussion Starter #6
I'll try it while the car is hot. Hopefully pb has penetrated enough at this point. If it doesnt work I'll chop em

Thanks and I'll keep y'all posted
 

·
Jeff
Joined
·
902 Posts
I was just having this issue today as well :(

I ended up stripping a bolt, even after lathering that shit in pbblast, so imma go to a shop to have them loosen for me
 

·
Registered
Joined
·
442 Posts
Discussion Starter #13
Thanks all. I ended up using a Torch to heat up the bolts and Lots more PB Blaster along with a huge breaker bar. They came off no problem after that :)
 

·
( o)( o)
Joined
·
964 Posts
Will be replacing my downpipe soon. Will be cutting the bolts to get it done as well
 
1 - 14 of 14 Posts
Top