So today i was really bored at home and decided to replace all my lights that are out for my 2005 tsx.
97,093 miles...
So all i needed was:
Screwdriver set
tweezers
sissors or nailclipper
4 radioshack bulbs
#7219 microlamp 12volt 50Ma
![Image]()
or
acura
35852-SDA-A01
35853-SDA-A01 ( HI / LO heat button)
#74 bulb for gear shift light same as the glovebox.
got a #74H from superbrightleds, its a bit too big but i modified it to fit. (electrical tape)
So first you pull out your center console and disconnect the wiring, then flip it over you will see the heater switches with screws.
unscrew the 4 screws. I took the whole center console inside with me...
![Image]()
Pry off the vsa and moonroof block with a flathead. Carefully so you don't scratch your car!!!!!!
Unplug the harness you won't have the extra wire since that led is for my alarm system.
![Image]()
![Image]()
This moonroof button is hard, you need to press the top clip with the screwdriver since you can't reach it with your finger.
![Image]()
The other one push both sides it slides out from the front of the plate.
![Image]()
![Image]()
To avoid losing any pieces or parts i brought everything inside.
Look at all the 4 switches.
![Image]()
This is how all the switches are it needs a flathead to unlock it. Carefully do it or you can strip the plastic.
![Image]()
The moonroof light is the hardest it gets stuck sometimes so use a small flathead to pry it out.
97,093 miles...
So all i needed was:
Screwdriver set
tweezers
sissors or nailclipper
4 radioshack bulbs
#7219 microlamp 12volt 50Ma
or
acura
35852-SDA-A01
35853-SDA-A01 ( HI / LO heat button)
#74 bulb for gear shift light same as the glovebox.
got a #74H from superbrightleds, its a bit too big but i modified it to fit. (electrical tape)
So first you pull out your center console and disconnect the wiring, then flip it over you will see the heater switches with screws.
unscrew the 4 screws. I took the whole center console inside with me...
Pry off the vsa and moonroof block with a flathead. Carefully so you don't scratch your car!!!!!!
Unplug the harness you won't have the extra wire since that led is for my alarm system.
This moonroof button is hard, you need to press the top clip with the screwdriver since you can't reach it with your finger.
The other one push both sides it slides out from the front of the plate.
To avoid losing any pieces or parts i brought everything inside.
Look at all the 4 switches.
This is how all the switches are it needs a flathead to unlock it. Carefully do it or you can strip the plastic.
The moonroof light is the hardest it gets stuck sometimes so use a small flathead to pry it out.
