Acura TSX Forum banner
21 - 40 of 143 Posts
I use tanabe sustec pro-gf its drop so nice and balanced,also same confort as before...and lowe price than others
i have no picture yet,i will update later
Image
 
TANABE SUSTEC PRO-GF
Image

Image
 
Tein SS -- approx 1 inch gap from tyre to wheel arch on all 4

Image

Image

Image

Image
 
tanabe sustec pro - gf kit
Image
 
with 19"rims..i think its good suspension,but not good for sport ride..soft,and helper suspension makes your car like factory feel..looks as you see

Image
 
Neuspeed Cup Kit with Neuspeed race springs.

I have the rears on the last perch and the drivers side front middle perch and passenger side front 1 down. Now the reason for this was once I sit in the car the drivers side goes down about 1/8 to 1/4 of an inch. So I measured all 4 corners and i'm sitting pretty level all around. The rears a bit higher but once I fill up with gas should lower a bit. Little suprised the rears not lower being its on the last perch.

Image

Image
 
Neuspeed Cup Kit with Neuspeed race springs.

I have the rears on the last perch and the drivers side front middle perch and passenger side front 1 down. Now the reason for this was once I sit in the car the drivers side goes down about 1/8 to 1/4 of an inch. So I measured all 4 corners and i'm sitting pretty level all around. The rears a bit higher but once I fill up with gas should lower a bit. Little suprised the rears not lower being its on the last perch.

Image

Image


car is clean as hell good job!
 
Image

Image

Image


Koni yellows and ground control coilovers (off the shelf spring rates)

first pic: 10 threads from the bottom (front), 9 threads (rear)
After 11 threads front, 9 threads. [i had trouble scraping on my driveway]
 
Buddy Club RSD
Still about 3" of tread left in the rear, ~2" of tread left in the front
-3 rear camber, -2 front camber

Image

brought it up ~.5" since my frame above the front wheel is full polished now lol
Image

Image
 
21 - 40 of 143 Posts